Skip to main content

Too much red tape, not sure where to start? Call Mitch directly at 021502429, let's make it happen together!

Driveways, access roads and farm tracks in Nelson, Tasman and Marlborough

Formed, drained and metalled driveways, shared rights of way, farm tracks and forestry roads, built from our Wakefield yard.

Driveway contractor for rural Nelson, Tasman and Marlborough

Aspect Contracting and Forestry builds rural driveways, shared access roads, farm tracks and forestry roads across Nelson, Tasman and Marlborough. We form, drain, metal and compact the road, and crush rock on site where it saves carting metal in. Every new or upgraded driveway in Tasman needs a council permit, and we talk you through it before we start.

Driveway and farm track work

Aspect carries out:

  • Lifestyle block driveways from the road to the house pad, with culverts and fire-appliance access.

  • Access formed for builders before the slab and finished after.

  • Farm and vineyard tracks and races, including flood repairs.

  • Shared rights of way on small subdivisions, passing bays included.

  • Culverts and table drains sized for the catchment.

  • Gravel supply, cartage and on-site crushing for basecourse and running course.

  • Forestry roads and skid access for forest owners.

A new vehicle crossing at the road needs council approval, and in Nelson City it must be built by a council-approved installer. We can talk you through the process and build the driveway behind it.

Related services: Site preparation and house sites · Gravel cartage and crushing · Drainage and culverts

From site visit to finished surface

1

Site visit and permit check

We look at sight distance, grade and the crossing point, and explain the permit.

2

Formation and drainage first

We strip topsoil, cut the formation with camber, and dig table drains and culverts before metal arrives.

3

Base layers

Basecourse goes down in compacted lifts of up to 150 mm, using rock crushed on site where it meets spec.

4

Surface

A 100–150 mm running course graded to a 3–8% crown, or preparation for two-coat chip seal where required.

5

Handover

Culverts bedded, final grade checked and photos supplied for your records.

In Nelson and Tasman, the Land Development Manual sets minimum carriageway widths of 2.5 m in rural zones, 2.75 m for a single residential or lifestyle unit and 3.0 m for 2 to 6 lifestyle units (NTLDM). In rural Tasman, track formation is permitted up to 100 m per hectare on slopes under 35° (TRMP Rule 18.5). Rules and thresholds change; we confirm the current position with your council before we quote.

Driveway and house site, Tasman: from pine block to building site

Aspect cleared a pine-covered rural block in Tasman, formed the driveway with three culvert crossings and cut the house site so the owners could build. The job involved around 4,500 m³ of cut-to-fill and the removal of more than 100 pine trees.

On a wind-damage salvage forestry job in Tasman, we also built more than 20,000 lineal metres of extraction tracks and roads.

4,500 m³

Cut to fill

100+

Pine trees removed

3

Culvert crossings

Driveways and farm tracks FAQs

Common questions from rural owners and builders planning access. Still unsure? Call Mitch on 021 502 429.

Do I need a permit for a new driveway in Tasman?

Yes. Under Tasman District Council's Policy 7, every new or upgraded driveway, vehicle crossing or accessway needs a council permit, and rural accessways must be two-coat chip sealed at the road (Tasman District Council). The permit checks sight distance, grade, surface and drainage. We can talk you through the process and build the driveway behind the crossing.

How much does a gravel or chip seal driveway cost?

Price depends on length, ground conditions, metal depth, culverts and crossings, and cartage distance. We price everything from a short rural driveway to kilometres of farm track. Your address and a rough route get you a ballpark over the phone; a site visit gives a fixed quote.

How thick should the gravel be on a driveway or farm track?

Lay base layers of up to 150 mm each, compacting each before the next, then a 100–150 mm running surface of crushed gravel, pit metal or rotten rock rather than river gravel (DairyNZ). Soft clay needs more base, or lime or cement stabilisation, than a gravel terrace.

How steep can a driveway be in Nelson and Tasman?

The Land Development Manual allows a maximum grade of 1-in-5 (20%) for residential and rural access, with 1-in-4.5 on straights up to 20 m. The first 6 m from the boundary is limited to 1-in-20 so vehicles can stop level before the road (NTLDM). Steeper sections need sealing.

What size culvert does a driveway need?

Where a driveway crosses a road swale drain in Nelson or Tasman, the minimum is 375 mm (NTLDM). Marlborough's minimum is 300 mm, sized to the catchment (Marlborough Roads). On farm tracks we size culverts for the catchment, not just the minimum.

Do I need a passing bay on a long shared driveway?

Yes. A shared private access longer than 50 m needs a passing bay at the start and at least every 50 m. Each bay is at least 5.5 m wide including the carriageway and 6.0 m long, with 4.0 m tapers (NTLDM). We build them into the formation.

How long does it take to build a rural driveway?

It depends on length, ground conditions, culverts and the crossing. A simple gravel driveway is a short job; one with bulk cut to fill, tree removal and several culverts takes longer, and we programme it with the quote. Tracks compact best in a dry spell, so book in spring for summer work.

What does Marlborough Roads require for a new vehicle crossing in Blenheim or Renwick?

A 4.0 m wide crossing, two-coat sealed from road edge to boundary on sealed roads or AP40 basecourse on unsealed roads, a 300 mm minimum culvert where the side drain is piped, an application fee and a two-year defects period (Marlborough Roads). We can talk you through the application and build the driveway behind the crossing.

What clients say

Request a quote

Send us the address and a rough route, and we will visit, check the rules and price it.

Call Mitch: 021 502 429

Email: info@aspecthub.co.nz

Aspect Contracting and Forestry, 65 Whitby Road, Wakefield

This site is protected by reCAPTCHA and the Google
Privacy Policy and Terms of Service apply.

Message Sent